GC Fuji Gold Label 9 BiG Pack | Posterior Restorative GIC | Restorative Cement
A high-strength strontium-based glass ionomer restorative provides all the properties of genuine glass ionomers with physical properties strong enough for use in posterior teeth.
As low as
₹1,786.40
In stock
Only %1 left
SKU
SBGCF01300
Price is inclusive of 12% GST
GC Fuji Gold Label 9 BiG Pack | Posterior Restorative GIC | Restorative Cement is available to buy in increments of 1
KEY FEATURES
- Chemical adhesion to tooth structure allows minimal cavity preparation without the need for etching or bonding agents
- A chemical setting without shrinkage allows single-step placement without layering
- Similar thermal expansion as tooth structure produces minimal stress on the marginal seal
- Strontium-based glass provides good radiopacity and snap-set characteristics unanimously preferred by clinicians
- Strontium-based fluoride-releasing formulation contributes to internal remineralization within tooth structure as well as increasing surface strength over time
- High compressive and flexural strength and 60% higher wear resistance than conventional glass ionomers make Gold Label 9 strong enough for use in posterior teeth
| Technical Specification | Gold Label IX Extra
Gold Label IX
|
|---|---|
| Product Components | Gc Gold Label 9 Extra - Big Pack
Gc Gold Label 9 Extra - Mini Pack
Gc Gold Label 9 - Big Pack
Gc Gold Label 9 - Mini Pack
|
| Directions to Use | DIRECTION TO USE 1. POWDER AND LIQUID DISPENSING
2. MIXING
4. FINISHING
|
Write Your Own Review
Gc Gold Label 9 Extra - Big Pack
- 1 x 15 g Powder
- 1 x 8 g Liquid(6.4ml)
Gc Gold Label 9 Extra - Mini Pack
- 1 x 5g Powder
1 x 3g Liquid(2.4ml)
Gc Gold Label 9 - Big Pack
- 1 x 15 g Powder
- 1 x 8 g Liquid
Gc Gold Label 9 - Mini Pack
- 1 x 5 g Powder
- 1 x 5 g Liquid(4ml)
DIRECTION TO USE
1. POWDER AND LIQUID DISPENSING
- The standard powder-to-liquid ratio is 3.4g/ 1.0g. (1 level scoop of powder to 1 drop of liquid).
- For accurate dispensing of powder, lightly tap the bottle against the hand. Do not shake or invert.
- To dispense the correct amount of liquid from the bottle turn the bottle upside down, keep the nozzle away from the mixing pad and gently press the bottle. =
- Discard the first 1 drop after opening a new bottle as the dispensed amount may not be accurate.
- Close bottles tightly immediately after use.
2. MIXING
- Dispense powder and liquid onto the pad. Using the plastic spatula, divide the powder into 2 equal parts.
- Mix the first portion with all the liquid for 10 seconds.
- Incorporate the remaining portion and mix the whole thoroughly for 15-20 seconds (Fig. 1).
3. RESTORATIVE TECHNIQUE
- Prepare the tooth using standard techniques. Extensive mechanical retention is not necessary. For pulp capping, use calcium hydroxide.
- Apply GC CAVITY CONDITIONER (10 seconds) or GC DENTIN CONDITIONER (20 seconds) to the bonding surfaces using a cotton pellet or sponge (Fig. 2).
- Refer to the respective instructions for use.
- Rinse thoroughly with water. Dry by blotting with a cotton pellet or gently blowing with an air syringe. DO NOT DESICCATE.
- The best results are obtained when prepared surfaces appear moist (glistening) (Fig. 3).
- Mix the required amount of GC Gold Label IX GP-EXTRA. Working time is 2 minutes from the start of mixing at 23°C (73.4°F). Higher temperatures will shorten working time.
- Transfer cement to the preparation using a syringe or other suitable instrument. Avoid air bubbles.
- From the preliminary contour and cover with a matrix if required (Fig. 4). g) When set, immediately apply GC Fuji VARNISH (blow dry) or GC Fuji COAT LC (light cure for 10 sec.).
4. FINISHING
- Final finishing under water spray using standard techniques can begin at 6 minutes after starting the mix.
- Apply a final coat of G-COAT PLUS and light cure for 20 sec. (Fig.5, 6). Alternatively, apply GC Fuji VARNISH (blow dry) or GC Fuji COAT LC (light cure for 10 sec.)
- Instruct the patient not to apply pressure for 1 hour.
