U Ortho VacuMold Portable Dental Vacuum Forming/Molding Machine

• Dimension: 25x21x30cm
• Thermoforming material size: 5" x 5"
• Voltage: 110V/60Hz
• Power supply: 1000W
• Machine weight: 6kg

• 1 x Dental Vacuum Suction Unit
• 1 x Pack of Beads
• 1 x Instruction manual

Safety Precautions:

• Before using the machine, ensure that you have read and understood the instructions and safety guidelines.
• Wear appropriate personal protective equipment, such as gloves and safety glasses, to protect yourself during the process.

Prepare the Thermoplastic Sheets:

• Select the appropriate thermoplastic sheet for the desired dental appliance.
• Cut the sheet into the required size and shape, allowing for proper coverage of the dental model or impression.

Preheat the Machine:

• Plug in the machine and turn ON the power.
• Adjust the temperature settings based on the recommendations provided by the manufacturer and the type of thermoplastic material being used.
• Allow the machine to preheat until the desired temperature is reached. This usually takes a few minutes.

Position the Dental Model or Impression:

• Place the dental model or impression on the platform of the machine, ensuring that it is centered and properly aligned.

Place the Thermoplastic Sheet:

• Carefully place the pre-cut thermoplastic sheet over the dental model or impression.
• Make sure that the sheet covers the entire area to be molded and that there are no wrinkles or folds.

Engage the Vacuum:

• Close the lid or cover of the machine securely, creating a sealed chamber.
• Activate the vacuum function by pressing the appropriate button or switch.
• The vacuum will create suction, pulling the thermoplastic sheet tightly around the dental model or impression.

Molding Process:

• Monitor the molding process closely.
• The thermoplastic sheet will soften and start to conform to the shape of the dental model or impression.
• The exact time required for molding will vary depending on the type of thermoplastic material and the manufacturer's instructions. Typically, it takes a few seconds to a minute.

Release the Vacuum and Remove the Molded Appliance:

• Once the desired molding time has elapsed, release the vacuum by turning off the machine or pressing the appropriate button.
• Open the lid or cover of the machine, exposing the molded appliance.
• Carefully remove the molded appliance from the dental model or impression, ensuring that it retains its shape and accuracy.

Trimming and Finishing:

• Trim any excess material from the molded appliance using dental instruments or scissors, following the specific instructions for the intended dental appliance.
• Smooth and finish the edges of the appliance as necessary, ensuring patient comfort and functionality.

Clean and Maintain the Machine:

• After each use, clean the machine.
• Remove any residual material or debris from the vacuum chamber and heating element.
• Store the machine in a safe and dry place to prevent damage.

• Upto 15 days